When working from an attic space it will be significantly easier to access a wall space on the floor below by working either an interior wall or the exterior wall that is on the gable end of the structure.
Will frontier run through attic for installation.
Frontier is using its best efforts in this regard.
First it may be tempting to run your upstairs bathroom fan straight into the attic space to avoid having to add roof vents in the first place.
The code states that the service conductors must be as short as practical inside the building which usually is interpreted as just enough to go through the soffitt into the meter then directly into a main panel.
Yes this should be corrected and it would be good to have the wiring and all the circuit connections inspected as well.
Raul no this is not a standard practice and is most likely the result of improper installation of electrical attic wiring.
Wire from the attic to the basement using a second floor hvac return green.
It will be more costly to run the linesets in the crawlspace and definitely easier to run them in the attic.
If the sites that you want to run wire to are on the outside of the house you should not need to drill a new hole.
Wire from the attic to a second floor outlet purple.
It will be next to impossible to drill downward under the portion of the roof that slopes to the attic floor without a right angle drill.
I have never seen attic wiring installed this way.
It looks like the circuits were added recently too.
All that warm moist air will condense once it comes in contact with the cooler air in the attic.
I took some pictures of the attic wiring at a clients home.
For a variety of reasons from pipe damage under a slab to home design constraints water pipes may need to be run or rerouted through a home s attic.
Venting through the attic.
Wire from the basement to a first floor outlet.
It may have been ok in the 50s to run through the attic but unfused service conductors running through the attic is not allowed any more.
When cutting through drywall from the interior of a room use a utility knife and cut carefully you don t want to drill through a hidden wire or the paper backing of the attic insulation.
From down in the basement the bottom of the floorboards.
The wiring is so close to the roof and run along the joists.
Frontier also reserves the right to delay postpone or cancel installation for reasons related to covid 19 and or state or local rules regulations or orders regarding covid 19.
However frontier accepts no liability for illness related to installation or the provision of frontier services.
This is in ontario.
Any service work would require compliance with modern code.
My installer is willing to run the linesets in either the attic or crawl for my minisplit.
They say that the wiring was put in to add a few lights to bedrooms and it was inspected.
For a first floor installation you will be drilling up through the floorboard and then sole plate.
Because there are.
That aside is one space better than the other to locate the lines.
The attic wiring should be protected and secured to ceiling joists or other wood structural supports.